Browse Categories
Mailing Lists

Thermocouple Extension Wire for Digital Remotes (by the foot)

Price: $3.00

⚠️IMPORTANT: Please do not order any thermocouples before calling us at (863) 648-0585 to confirm that you are selecting the correct one for your kiln.

This type K wire runs from the digital controller to the the connecting block where the thermocoupler is attached. It sends a low voltage signal back to the controller to display the temperature.  The Red thermo wire must hook up to the red connection at the controller and the red connection at the block and then the red side of the thermocoupler.   If wired improperly the controller usually reads down in temperature as the kiln heats.  Make sure this thermo wire is pushed away from the 120v or 240v wires.  It could read wrong if the thermo wire runs along side one of the high voltage wires.  On a Digital Remote unit do not let this wire runs attached to the kilns power cord.  This thermocoupler wire needs to run to the kiln without touching the power cord.   Do not tie the thermowire to the cord or it will read wrong and may not fire correctly. It takes about 10 minutes to change this part.  Sold by the foot and usually 6 feet is needed.


Kiln serial number (located on top right of control box) and any notes on this kiln:
Shopping Cart
Your cart is empty.
Jen-Ken Kilns Exclusive Fiber Kilns!