Brown Thermocouple Wire for Internal Thermocouples

⚠️ IMPORTANT: Before ordering any thermocouples or thermocouple wires, please call us at (863) 329-KILN to confirm you're selecting the correct one for your kiln.

This high-temperature type K wire runs from your kiln's digital controller to the connecting block where the thermocouple is attached. It sends a low-voltage signal to the controller, allowing it to display the kiln's temperature accurately.

Replacing this part typically takes about 10 minutes.

• The red thermocouple wire must connect to the red terminals on both the controller and the block, as well as the red side of the thermocouple.

• Improper wiring may cause the controller to show a lower temperature as the kiln heats up.

• Keep the thermocouple wire away from 120V or 240V high-voltage wires, as proximity can cause incorrect readings.